wiring harness?--how to remove ?
Thread Starter
Joined: Mar 2001
Posts: 2,721
Likes: 0
From: c-town AKA Crofton Md
wiring harness?--how to remove ?
Guys,how can you remove the wiring harness(main) off the motor with the motor still in the car.Is there an easy solution.I have looked all over for a disconnect from the passenger side firewall to the motor and i dont see anything.Its a 86 gxl
If your talking about the ECU to MOTOR harness. Its easy to disconnect the harness at the ECU, and feed the wires through. Ive replaced motors without having to disconnect the ECU harness from the motor.
You just disconnect at the ECU, and feed the harness out the pass side firewall. Then feed the new harness back in. Easy cheesy.
Jarrett
You just disconnect at the ECU, and feed the harness out the pass side firewall. Then feed the new harness back in. Easy cheesy.
Jarrett
Former Moderator. RIP Icemark.
Joined: Apr 2001
Posts: 25,896
Likes: 24
From: Rohnert Park CA
yep I agree with Jarrett. Just unplug the ECU harness inside the car and feed it out into the engine compartment.
You may have to unplug the wiper motor as well, I can't remember off the top of my head without looking at it.
You may have to unplug the wiper motor as well, I can't remember off the top of my head without looking at it.
Thread
Thread Starter
Forum
Replies
Last Post
82streetracer
1st Generation Specific (1979-1985)
7
Aug 23, 2015 09:28 AM