Which Wire To Splice On Fuel Pump?
#1
Senior Member
Thread Starter
Join Date: Aug 2004
Location: San Francisco
Posts: 588
Likes: 0
Received 0 Likes
on
0 Posts
Which Wire To Splice On Fuel Pump?
just a quick question, i couldnt figure out which was the best wire to splice on the fuel pump harness for my kill switch.
thanks 88 gtu
thanks 88 gtu
#4
I'm a boost creep...
Join Date: Jan 2002
Location: Auckland, New Zealand
Posts: 15,608
Likes: 0
Received 8 Likes
on
8 Posts
There are two signal wires to the circuit opening relay, so your switch needs to intercept the power instead. The B wire (black with a white stripe) is the power supply and the Fp wire (blue with a red stripe) goes to the fuel pump. The switch can go into either of these wires, it doesn’t matter which. Simply cut the wire, extend each cut end to your chosen switch location using the same or thicker gauge wire and terminate them onto the switch. Note that the STA wire is also black with a white stripe, but it’s thinner. Make sure you get the right wire.
Thread
Thread Starter
Forum
Replies
Last Post
trickster
2nd Generation Specific (1986-1992)
25
07-01-23 04:40 PM
LunchboxSA22
2nd Generation Specific (1986-1992)
37
10-26-15 10:53 AM
ChrisRX8PR
Single Turbo RX-7's
21
10-18-15 04:01 PM
befarrer
Microtech
3
08-22-15 05:52 PM