2nd Generation Specific (1986-1992) 1986-1992 Discussion including performance modifications and technical support sections.

Why Is My 7 Buzzing Constantly! Help!

Thread Tools
 
Search this Thread
 
Old Oct 19, 2006 | 12:30 AM
  #1  
MazdaSpeedRX7707's Avatar
Thread Starter
MazdaSpeedRX7
Tenured Member 05 Years
 
Joined: Oct 2004
Posts: 62
Likes: 0
From: Santa Rosa Ca.
Why Is My 7 Buzzing Constantly! Help!

I keep getting my add coolant light constantly going off, but now the light went out but the buzzing got real loud like the little buzzer speaker was going to blow. I was having a problem with coolant loss but i put a new water pump and radiator cap in it doesn't seem to be overheating but i don't trust my stock gauge. I am not seeing any visual leaks and the coolant is in the neck but sometimes i have to add like a pint to fill it back up could i have an air bubble. Could it be a sensor, a thermostat, a radiator could you please help thanks greatly appreciated.
Reply
Old Oct 19, 2006 | 01:03 AM
  #2  
NZConvertible's Avatar
I'm a boost creep...
Tenured Member 05 Years
 
Joined: Jan 2002
Posts: 15,608
Likes: 8
From: Auckland, New Zealand
Have you properly bled the cooling system of air? Fill it up until you can see coolant in the filler neck and run the engine with the heater fully open and filler cap removed. Let it warm right up until the thermostat opens (the upper radiator will get hot) and there are no more bubbles appearing, then top it up and replace the cap.
Reply
Old Oct 19, 2006 | 03:45 AM
  #3  
Carzy Driver's Avatar
Law Breaker
Tenured Member: 15 Years
 
Joined: Oct 2005
Posts: 3,333
Likes: 0
From: S.F. Bay Area, California 510
check for shorts on the coolant sensor wire if you're not low on coolant..
Reply
Old Oct 19, 2006 | 10:34 AM
  #4  
mort2002's Avatar
Rotary Enthusiast
Tenured Member 10 Years
iTrader: (1)
 
Joined: Jul 2003
Posts: 1,248
Likes: 0
From: Prosser Washington
well what is your radiator overflow bottle doing. if it is filing up, and almost starting to overfill, you may have a leak in the hose to the overflow bottle, if there is a lil hole in it, it will allow the coolant to travel to the bottle but not back into the radiator, also check for a blown coolant seal in the motor. take the radator cap off and crank the engine over, if you see coolant coming out of the radiator you have a poped coolant seal.
Reply
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
WyomingTII
2nd Generation Specific (1986-1992)
12
Sep 28, 2015 10:32 AM
RyanFox
New Member RX-7 Technical
7
Sep 18, 2015 09:09 PM
The1Sun
1st Generation Specific (1979-1985)
7
Sep 18, 2015 07:13 PM
ChanBagz
2nd Generation Specific (1986-1992)
6
Sep 17, 2015 03:36 PM
The1Sun
New Member RX-7 Technical
5
Sep 15, 2015 04:45 PM




All times are GMT -5. The time now is 09:23 PM.