i can seem to find any FMIC for my car. Anyone know of any places that sell them?
Also i figured out what upgrade path i want to go with my car

I have a street port rebuilt motor right now with 90 compression all around
i was thinking of getting the GT35/40 Turbo but i need a T4 flange and i dont know where to get the adaptor to go to my 3 bolt 3" downpipe.
For fuel im going to get Microtech MT-8 with 550cc primary and 1000cc secondary (does anyone know if the LT-8 is worth getting over the older MT-8?
Profec B spec II boost controller
ACT Prolite flywheel
ACT 6 Puck clutch
New tubular exhaust manifold with a 40MM external wastegate
Koyo Aluminum Radiator

If anyone has any advice about which turbo to get because the GT35 is going to run me around $1300.

Car is running excellent right now but the stock turbo is shot runs to 5psi only because of the wastegate just flaps around and the turbine has a lot of shaft play

 

Are you serious? A simple google search for "87 RX-7 intercooler" pops up over 39,000 results with both the popular aftermarket Greddy and HKS FMIC offerings in the first couple pages.

 

alright found some before i was just finding 3rd gen intercoolers any feedback on the turbo setup

 

the newer microtechs are better built.
as for your fuel your going to need a lot more fuel than that.
heres a basic fuel calc.
http://rx7.com/cgi-local/2ndgencalc.cgi

 

i was just advised to get the LT-10 unit the tunign shop i spoke to said 550cc primary and 1000cc secondary will be enought to run a gt35 with 15PSI

 

im shure they would run up to 15psi, you would go lean and have to rebuild. 1000cc's will work for my TO4B but not for a gt35.
doing a quick search for a GT35/40 dyno sheet shows 370whp @13psi so you can assume something closer to 390whp at 15psi. or ~450bhp. (all very rough #'s do not expect to match 100%)
I'd do something like 720primary 1680 secondary.

 

FMIC I would suggest buying the greddy kit for $899 and all the other stuff can be found at www.ATPturbo.com
These guys will have everything you need for you build. Trust me I have ordered from them like 10 times.

 

Click on the picture in my sig for custom work (manifolds and downpipes):