Ive looked everywhere for a gauge pod for my TII, im in the middle of a dash swap and i want to wire everything while the dash is out. but i need a gauge pod so i can run my wires. all i can find is those stupid clip on dual a-pillar pods..im looking for anything but those. id prefer one that mounts near the radio above or below it...need one that holds 3 gauges...i dont care what it cost i just need one ASAP..lol

 

There's one that mounts where the idiot lights are, I don't know who makes it though. There's also ones that mount in the center console... don't know where to get those either. Might want to go check out the classifieds section.

 

try egauges. i was lookin around there earlier today. i found some nice little DIN Defi gauges. 2 temp and one pressure. only problem is that its not Imperial units, so yeah. hope that site helps you out!

 

ok i looked on that egauges site and couldnt find what your talking about.. and i already searched the classifieds and everywhere else on this site

 

I bought one off a forum member that was making them a while ago, I forget who was selling them, I'll try to look back in my pms and find out....

 

The guy who was selling them's forum name is "1FastT2" but that was a long time ago... (in 2003).

here's the thread:
https://www.rx7club.com/2nd-generation-specific-1986-1992-17/gauge-panels-still-available-if-interested-153030/

sorry I couldn't be more help I didn't realize it was that long ago....

 

Just make one. There are plenty of reference photos.