2nd Generation Specific (1986-1992) 1986-1992 Discussion including performance modifications and technical support sections.

What have you replaced on your FC?

Thread Tools
 
Search this Thread
 
Old May 22, 2002 | 06:57 PM
  #1  
telus.net's Avatar
Thread Starter
Full Member
Tenured Member 05 Years
 
Joined: May 2002
Posts: 209
Likes: 0
From: B.C.
What have you replaced on your FC?

I am wondering what you have replaced on your FC? I am only interested in something mechanical like engine parts, suspension, rebuilts, axle, or whatever!

THANKS!
Reply
Old May 22, 2002 | 07:07 PM
  #2  
Silkworm's Avatar
Has been.. hangin' around
Tenured Member 10 Years
 
Joined: Mar 2001
Posts: 2,618
Likes: 0
From: Milpitas, CA
What havent' I replaced is closer to reality..

Shortlist:

Engine block, intake manifold, AFM, BAC, TB, injectors, Alternator, water pump, waterpump housing, engine side wiring harness, heater lines, vacuum lines, atmospheric pressure sender, front wiring harness (THAT was a bitch), shifter, transmission, exhaust header, exhaust, shocks, springs, lower ball joints, rotors, calipers, front hub bearings, bushings all around, oil pressure sender, water temperature senders (x2), oil cooler lines, master cylinders (brake/clutch), clutch slave cylinder, all brake lines (hardlines too, converted from ABS to non), rear diff mounts, engine mounts, trans mounts..



PaulC
Reply
Old May 22, 2002 | 07:11 PM
  #3  
telus.net's Avatar
Thread Starter
Full Member
Tenured Member 05 Years
 
Joined: May 2002
Posts: 209
Likes: 0
From: B.C.
Do you have problems with all these things? Or are you just a perfectionist wanting everything new?

Seriously, I will just relube the cables and wash out older parts to make it work better.
Reply
Old May 22, 2002 | 07:15 PM
  #4  
vaughnc's Avatar
knowledge junkie
Tenured Member 10 Years
 
Joined: Mar 2001
Posts: 5,595
Likes: 6
From: Atlanta, GA
Turbo II (148k miles)- TPS (throttle position sensor), exhaust manifold (broke/warped from the previous owners engine install), brake booster (pedal syncing to the floor)

Convertible (101K miles)- trans syncros, TPS, exhaust system

TII could use new shocks or coilovers as it's a bit bumpy and I'm sure the rear bushings need replacing (aka rear steer).
Reply
Old May 22, 2002 | 07:16 PM
  #5  
rico05's Avatar
WTB S5 N/A FC
Tenured Member 10 Years
 
Joined: Oct 2001
Posts: 2,778
Likes: 0
From: College Station, Tx
Silkworm has an actual off road racecar, so he can do a few things that we can't. All I have needed to replace on my 91 are: Shifter bushings, clutch, and inside door handles. Everything else is tip top for a 101,231 mile RX-7...
Reply
Old May 22, 2002 | 07:25 PM
  #6  
Silkworm's Avatar
Has been.. hangin' around
Tenured Member 10 Years
 
Joined: Mar 2001
Posts: 2,618
Likes: 0
From: Milpitas, CA
Start with an 88 RX-7 with 215K miles.

Have a PD fire that wipes out all the plastic, wiring, injecotrs, and most of the aluminum engine partsl on the passenger side.

Add in carelessness with painting the car(necessitating the front harness replacement).

Then factor in the desire to NOT HAVE TO DO THIS **** AGAIN, and that's where all the replacing came from.



Cya

PaulC
Reply
Old May 22, 2002 | 07:38 PM
  #7  
Felix Wankel's Avatar
Super Newbie
Tenured Member 10 Years
 
Joined: Feb 2001
Posts: 4,398
Likes: 1
From: Birmingham, AL
Between them all, three clutches, an engine, two driveshafts, and about 4 sets of brake pads.

This doesn't count mods. I'd run out of room

Edit: Why the **** do I keep buying these things?!

rear diff mount, AC compressor, trans mount, engine mounts x3, shifter bushings, radiator x2, oil cooler lines, rear wheel bearings.

Last edited by Felix Wankel; May 22, 2002 at 07:41 PM.
Reply
Old May 22, 2002 | 07:49 PM
  #8  
QC Motorsports
Tenured Member 20 Years
 
Joined: Jan 2002
Posts: 759
Likes: 0
From: Austin, tx
So Silkworm,
Blue mirrors on a yellow car.
???
Tell us the story.
Charles
Reply
Old May 22, 2002 | 07:56 PM
  #9  
Silkworm's Avatar
Has been.. hangin' around
Tenured Member 10 Years
 
Joined: Mar 2001
Posts: 2,618
Likes: 0
From: Milpitas, CA


Seriously.

I have rainbows painted on the back of the bumper.

hehehe

No, no..

Just wanted a different color, blue looked better than red did.. Gotta give SOME clues that it's not a street car.

Besides, it's totally riced out anyway.. What's one more thing ALl that's missing is that goober sticker from the side of that F&F supra.

PaulC
Reply
Old May 22, 2002 | 07:58 PM
  #10  
brap brap
Tenured Member 20 Years
 
Joined: May 2002
Posts: 121
Likes: 0
From: Migrated back to Gulf Breeze, FL
new clutch... lighten flywheel...

Rest of the mods I want to do in the near future.
Reply
Old May 22, 2002 | 08:11 PM
  #11  
Evil Aviator's Avatar
Rotorhead
Tenured Member 15 Years
 
Joined: Feb 2001
Posts: 9,136
Likes: 39
From: Charlottesville, Virginia, USA
Originally posted by Silkworm
What havent' I replaced is closer to reality..
LOL, don't get me started.
Reply
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
t-von
3rd Generation Specific (1993-2002)
9
Sep 10, 2015 01:56 PM
BLK 93
3rd Generation Specific (1993-2002)
11
Sep 9, 2015 10:56 AM
Frox
General Rotary Tech Support
2
Sep 8, 2015 08:36 AM
Enzo1944
New Member RX-7 Technical
2
Sep 6, 2015 08:57 AM




All times are GMT -5. The time now is 09:51 PM.