RX7Club.com - Mazda RX7 Forum

2nd Generation Specific (1986-1992) 1986-1992 Discussion including performance modifications and technical support sections.

what does this do or go to?

Thread Tools
 
Search this Thread
 
Old Jun 2, 2011 | 04:31 PM
Share
  #1  
mig82rx7's Avatar
mig82rx7
Thread Starter
Full Member
Tenured Member 10 Years
iTrader: (2)
 
Joined: Dec 2005
Posts: 131
Likes: 0
From: del rio tx
what does this do or go to?
i found this in the engine bay behind the passnger headlight it is cut was wondering whats it for or if its needed the cars a 88 turbo thnks for the help

Reply
0
Old Jun 2, 2011 | 04:43 PM
Share
  #2  
blackrotary23's Avatar
blackrotary23
snap crackle brap
Tenured Member 05 Years
 
Joined: Dec 2007
Posts: 536
Likes: 0
From: indianapolis, indiana
that is the resistor that is supposed to be connected to the fuel pump solenoid relay..
Reply
0
Old Jun 2, 2011 | 04:52 PM
Share
  #3  
JerryLH3's Avatar
JerryLH3
Rabbit hole specialist
Tenured Member: 25 Years
Community Favorite
iTrader: (11)
 
Joined: Feb 2001
Posts: 2,852
Likes: 225
From: Tampa, FL
It is the fuel pump resistor and necessary for stock fuel pump wiring.
Reply
0
Old Jun 2, 2011 | 04:53 PM
Share
  #4  
mig82rx7's Avatar
mig82rx7
Thread Starter
Full Member
Tenured Member 10 Years
iTrader: (2)
 
Joined: Dec 2005
Posts: 131
Likes: 0
From: del rio tx
i guess the prev owner cut if off the car runs fine should i just leave it alone
Reply
0
Old Jun 2, 2011 | 04:54 PM
Share
  #5  
blackrotary23's Avatar
blackrotary23
snap crackle brap
Tenured Member 05 Years
 
Joined: Dec 2007
Posts: 536
Likes: 0
From: indianapolis, indiana
the resistor is not needed. you can also use hailers method by taking all the solid blue wires and jumper them to all the blue/red wires. this bypasses the relay and resistor setup.
Reply
0
Back to Subforum
2nd Generation Specific (1986-1992)
View Next Unread
Transmission swap




Advanced Search

All times are GMT -5. The time now is 07:24 AM.