since i recently found out the wiring on my 88 TII was screwed i bought a new harness from a guy on the forum along with a refurbished ECU, i also opened up the intake and installed a aftermarket BOV. after that was all installed:

I roll it out of the garage go to start it and it starts to run!!! and stops
so i try again and its back to square one. it turns over but it wont start, im just so tired of this... any ideas? (im gonna check fuel and spark)

-Sean

 

got spark

 

could the BACV, if not working, be the cause of my problems how do i check??

 

i all of my fuses are good as well,

I kinda need ideas and things to check fast, because im going back to school today!