Voltage vs. Resistance HELP!!!
#1
Full Member
Thread Starter
Join Date: Nov 2004
Location: maryland
Posts: 237
Likes: 0
Received 0 Likes
on
0 Posts
Voltage vs. Resistance HELP!!!
Okay i need help fast, i think my tps is bad. Fully warm i set the tps at 1 kohm but if i check the voltsdc i get 1.46v.
Aren't these two methods of testing the tps supposed to be close to each other??
Would those reading being off that much mean i have a bad tps?????
Aren't these two methods of testing the tps supposed to be close to each other??
Would those reading being off that much mean i have a bad tps?????
#3
HAILERS
Join Date: May 2001
Location: FORT WORTH, TEXAS,USA
Posts: 20,563
Likes: 0
Received 21 Likes
on
19 Posts
The FSM says the voltage for the narrow range should be approx 1Vdc with a hot engine idling.
Either that or set it using the two LED method. You'll find that when you get throung the voltage output will still be approx 1vdc.
Either that or set it using the two LED method. You'll find that when you get throung the voltage output will still be approx 1vdc.
#6
Full Member
Join Date: Aug 2004
Location: San Bernardino County, Camp Pendleton, Kissimmee Fl.
Posts: 178
Likes: 0
Received 0 Likes
on
0 Posts
Thread
Thread Starter
Forum
Replies
Last Post