Using the low fuel sender without factory harness
#1
Using the low fuel sender without factory harness
Hey bro's, been awhile. Hope all is well. Anyway, in this new box of shenanigans I've decided to build, I'm running a bare bones harness (no lights even at this point) and I want to know if I can use the factory low fuel sensor to illuminate a light on the dash? It'd be a buttload cheaper then an aftermarket fuel gauge and since none of OHM's translate anyway, a gauge wouldn't be that accurate. Just something to light up if the levels low would be cool. Thank you for looking
If I were able to run it, would I just connect a wire to it, route it to the dash, hook it up to an LED or whatever I have lying around and that would do the trick?
If I were able to run it, would I just connect a wire to it, route it to the dash, hook it up to an LED or whatever I have lying around and that would do the trick?
Thread
Thread Starter
Forum
Replies
Last Post
streetlegal?
New Member RX-7 Technical
13
03-17-22 02:46 PM
82streetracer
1st Generation Specific (1979-1985)
7
08-23-15 09:28 AM