Used Transmission
Thread Starter
Full Member
Joined: Sep 2016
Posts: 89
Likes: 0
From: Gilbert, AZ
Used Transmission
So, after finding out the engine in the hatch is shot, I decided to swap the transmission from the hatch, into the convertible. My question is, is there any seals or bearing or anything that I would need to replace when I swap the transmission over.
Or is it as simple as drop and swap?
Or is it as simple as drop and swap?
Joined: Sep 2005
Posts: 25,581
Likes: 136
From: Smiths Falls.(near Ottawa!.Mapquest IT!)
as long as you got the cross member then you are good to go,
You can't use a S5 mount on an S4 Trans,and vice versa.
Also if it is N/A then you need to toss an N/A drive shaft on..as a TII drive shaft will not fit a N/A trans.
You can't use a S5 mount on an S4 Trans,and vice versa.
Also if it is N/A then you need to toss an N/A drive shaft on..as a TII drive shaft will not fit a N/A trans.
Thread Starter
Full Member
Joined: Sep 2016
Posts: 89
Likes: 0
From: Gilbert, AZ
Both are NA S5. The hatch is a 1990 GTU/GTX with a failed apex seal on each rotor. The vert is a 1991 with a locked transmission, pending a good crack open when I remove it to see what happened.