RX7Club.com - Mazda RX7 Forum

RX7Club.com - Mazda RX7 Forum (https://www.rx7club.com/)
-   2nd Generation Specific (1986-1992) (https://www.rx7club.com/2nd-generation-specific-1986-1992-17/)
-   -   Used Transmission (https://www.rx7club.com/2nd-generation-specific-1986-1992-17/used-transmission-1116861/)

Saminya 07-21-17 05:14 AM
Used Transmission
 
So, after finding out the engine in the hatch is shot, I decided to swap the transmission from the hatch, into the convertible. My question is, is there any seals or bearing or anything that I would need to replace when I swap the transmission over.
Or is it as simple as drop and swap?

misterstyx69 07-21-17 06:21 AM
as long as you got the cross member then you are good to go,
You can't use a S5 mount on an S4 Trans,and vice versa.
Also if it is N/A then you need to toss an N/A drive shaft on..as a TII drive shaft will not fit a N/A trans.

Saminya 07-21-17 07:10 AM
Originally Posted by misterstyx69 (Post 12201985)
as long as you got the cross member then you are good to go,
You can't use a S5 mount on an S4 Trans,and vice versa.
Also if it is N/A then you need to toss an N/A drive shaft on..as a TII drive shaft will not fit a N/A trans.
Both are NA S5. The hatch is a 1990 GTU/GTX with a failed apex seal on each rotor. The vert is a 1991 with a locked transmission, pending a good crack open when I remove it to see what happened.


All times are GMT -5. The time now is 04:49 AM.


© 2024 MH Sub I, LLC dba Internet Brands