Ummm need help! BIG CRACK!
#1
Ummm need help! BIG CRACK!
Well I am installing my toe elminators, and after I removed the rotor I noticed this grand canyon of a crack of the hub w/teeth on it for the ABS.
First of all I have no idea of how that would happen, the other side is fine, any ideas? How much of a problem is this? I know the best solution would be to replace it, but is there anything else, for atleast a while (jb weld)?
Anyways here is the pic...
First of all I have no idea of how that would happen, the other side is fine, any ideas? How much of a problem is this? I know the best solution would be to replace it, but is there anything else, for atleast a while (jb weld)?
Anyways here is the pic...
#2
OBEY YOUR MAZDA
that thing rotates at high velocity, I seriously doubt JB Weld would help.
If I were you IdŽ replace it before driving the car again. If that thing shatters at highway speed youre are in deep ****
If I were you IdŽ replace it before driving the car again. If that thing shatters at highway speed youre are in deep ****
Thread
Thread Starter
Forum
Replies
Last Post
Devon300zx
2nd Generation Specific (1986-1992)
8
09-22-15 12:07 PM