Turning an s4 na harness to s4 turbo 2
#1
Need na haltech base map
Thread Starter
iTrader: (5)
Join Date: Sep 2009
Location: az
Posts: 326
Likes: 0
Received 0 Likes
on
0 Posts
Turning an s4 na harness to s4 turbo 2
I picked up an 86 s4 gxl from a friend. It came with a t2 diff and trans already. I recently aquired an s4 t2 motor, extra trans and harness, but like most of the s4 t2s that I have seen the harnees is complete ****. I do however have the s4 na harness that was in the car, so I was wondering how t o go about making the na harness work for my turbo application. The first thing I did was troll around the archives found a couple useful things but nothing really explaining everything. Thanks in advance for any help.
Brandon
Brandon
#2
Full Member
Join Date: Apr 2007
Location: west chicago
Posts: 134
Likes: 0
Received 0 Likes
on
0 Posts
https://www.rx7club.com/2nd-generati...rness-1038589/
.....5 seconds lol no need for the extra harness you just extend a couple plugs and gtg
.....5 seconds lol no need for the extra harness you just extend a couple plugs and gtg
#3
Retired Moderator, RIP
iTrader: (142)
Join Date: Sep 2005
Location: Smiths Falls.(near Ottawa!.Mapquest IT!)
Posts: 25,581
Likes: 0
Received 131 Likes
on
114 Posts
https://www.rx7club.com/2nd-generati...rness-1038589/
.....5 seconds lol no need for the extra harness you just extend a couple plugs and gtg
.....5 seconds lol no need for the extra harness you just extend a couple plugs and gtg
But in a sense it still applies.You need to extend the BAC wires,and a few others..not a big deal.
and cut the PS wire at the ECU..as it would normally go to the knock sensor(after the swap with the N/A harness on there) and the engine would go to lower RPM when you turn!
A search would show you what to do,as it has been done countless times.
#4
Need na haltech base map
Thread Starter
iTrader: (5)
Join Date: Sep 2009
Location: az
Posts: 326
Likes: 0
Received 0 Likes
on
0 Posts
Quote:
Originally Posted by RotaryRocket88 View Post
Extend TPS wires or do not use any factory mounting hardware for the harness and it might stretch to fit
Cut off VDI plug & attach ECU wire to knock sensor (Pin 2M)
Plug 6PI plug into turbo duty solenoid (Pin 3R) if you still have it in your car which i do not so this step can be skipped if all the emissions and "unecessary things" are removed
__________________
Originally Posted by RotaryRocket88 View Post
Extend TPS wires or do not use any factory mounting hardware for the harness and it might stretch to fit
Cut off VDI plug & attach ECU wire to knock sensor (Pin 2M)
Plug 6PI plug into turbo duty solenoid (Pin 3R) if you still have it in your car which i do not so this step can be skipped if all the emissions and "unecessary things" are removed
__________________
Thread
Thread Starter
Forum
Replies
Last Post
trickster
2nd Generation Specific (1986-1992)
25
07-01-23 04:40 PM