Well, yesterday i was trying to connect my fog lights to the city light switch, but i connected it wrong and my blinkers don't work, in he en conncted it right to the side city lighhts, but now i have no blinkers, is there any fus i can check or antything i can o to bring them back?

 

come on guys, it sucks driving around with no turn signals, amnd i can't put the blinkers on the rear when i smoke a honduh.

 

That's pretty lame....

Replace the turn signal switch. Also, check out http://www.aaroncake.net/rx-7/lights.htm before you try again.

 

that would have been a little simple, im not that dumb bro, i already checked, anything else it could be?>

 

Well, if you have proven the the switch is not bad (ie. by swapping in a known good unit) then start to look at the CPU. While you are removing the CPU, remove the fuses one by one and check them with a continuity tester. Once you have the CPU removed, you will need to check the flasher and signal relays and related circuit board traces.

 

ahhhhh, thats a good solution, thanks aaron, il get on it.

 

jpg....sure its not just the fuse??? See the 10a one just above the flasher unit in the jpg??? No fuse, no worky.