Turn Signal
Thread Starter
Newbie
Joined: Apr 2002
Posts: 4
Likes: 0
From: Maryland
Turn Signal
All of a sudden neither of my turn signals work. The hazards work so I know it isn't a bulb. I looked at the wiring diagram and can not figure out why the hazards will work but the turn signal won't. Any ideas?
Nothing to see here.
Joined: May 2001
Posts: 1,255
Likes: 1
From: Jacksonville, FL
First check your fuses. If ok, then resolder the connectors in the Hazard CPU. The CPU is located on the drivers side, behind the left kick panel in the footwell. Held on with one 10mm (?) nut and it has two connectors attached.
GL.
B
GL.
B
Thread
Thread Starter
Forum
Replies
Last Post
The1Sun
1st Generation Specific (1979-1985)
7
Sep 18, 2015 07:13 PM
Farkel
3rd Generation Specific (1993-2002)
4
Sep 16, 2015 06:16 PM
The1Sun
New Member RX-7 Technical
5
Sep 15, 2015 04:45 PM