2nd Generation Specific (1986-1992) 1986-1992 Discussion including performance modifications and technical support sections.
Sponsored by:

Turbovert help needed!

Thread Tools
 
Search this Thread
 
Old 09-28-09, 11:45 PM
  #1  
ZOOM-ZOOM Forever!

Thread Starter
iTrader: (-1)
 
RotarySupra's Avatar
 
Join Date: Jun 2005
Location: SoCal/Arizona
Posts: 512
Likes: 0
Received 0 Likes on 0 Posts
Turbovert help needed!

well yesterday i drove my vert on the highway,i was going about 80mph when the car suddenly died and all my warning lights came on.when i pulled over and try to start it,it didnt start.after the third try it turned on,as i put it 1st gear to take off,the engine revved up and down between 1k and 3500 rpm while i smashed the throttle to the floor.it idles fine but when i put it gear and try to take off,the rpm bounces between 1k and 3500 rpm again.i noticed after i let the car cool down about 10 min and i disconnect the battery and the MAF the car runs fine.im really lost on the this and i was thinking about replacing the MAF,and before i did i was wondering if i can get some help.Thanks in Advance.
Old 09-30-09, 08:54 PM
  #2  
Trunk Ornament

iTrader: (11)
 
AGreen's Avatar
 
Join Date: Sep 2006
Location: Goose Creek, SC
Posts: 3,054
Likes: 0
Received 2 Likes on 2 Posts
Originally Posted by RotarySupra
...it idles fine but when i put it gear and try to take off,the rpm bounces between 1k and 3500 rpm again.i noticed after i let the car cool down about 10 min...
Right there. It's your tps being masked by the neutral switch. Adjust the tps, and check back for further diagnostic help.
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
David Hayes
3rd Generation Specific (1993-2002)
13
09-05-22 12:45 PM
runner83
1st Gen General Discussion
16
08-26-15 05:16 PM



Quick Reply: Turbovert help needed!



All times are GMT -5. The time now is 08:29 PM.