Turbo 2 coolant routing for efr turbo
#2
Full Member
A (back of the water pump) is for the thermowax through a barb on the rear iron through the throttle body to A. The turbo is circulates through a hardline on the lower intake manifold through the turbo to "B" on the lower section of the water pump.
#4
Full Member
This is how I understand it so anyone can correct me if I'm mistaken. This is the way coolant circulates once the thermostat opens and it can draw water from the lower part of the pump housing that's attached to the lower part of the radiator.
flow path
The bottom barb is for the stock return from the turbo and coolant is drawn through it since it's on the "cool" side. the top barb is the thermowax coolant return.
barbs on back
You can see the top barb ends right before the thermostat so once that opens coolant should circulate out this upper part if you use them to water cool a turbo since one on the "hot" side and the other is on the "cool" side it should circulate around fine.
inside upper part of housing
flow path
The bottom barb is for the stock return from the turbo and coolant is drawn through it since it's on the "cool" side. the top barb is the thermowax coolant return.
barbs on back
You can see the top barb ends right before the thermostat so once that opens coolant should circulate out this upper part if you use them to water cool a turbo since one on the "hot" side and the other is on the "cool" side it should circulate around fine.
inside upper part of housing
Last edited by Mlammert; 11-11-18 at 09:19 PM. Reason: grammar
Thread
Thread Starter
Forum
Replies
Last Post
Turblown
Group Buy & Product Dev. FD RX-7
7
03-21-18 11:19 AM
fd0
Single Turbo RX-7's
19
08-04-09 03:51 PM