Ok first off, yes, i;ve searched. I even posted the manual in another thread.

However here's my question.
I have the complete trust IC kit, but its designed for a greddy aftermarket turbo kit. It doesn't quite fit. Anyone who had this kit, how did you adapt compressor piping to the inlet on the IC?

 

Here's a pic of the part that doesnt fit in the manual.

 

for these kits the turbo(copresion housing) is supose to be rotated 180 degrees, so that the exit of the compresor point down... and ataches to the pipe.

I read you post again, so yhea a muffler shop that does mandrel bends would help....



gil