trans problems

Reply Subscribe

Thread Tools

Search this Thread

Nov 6, 2010 | 05:59 PM

fc323

Thread Starter

Senior Member

Joined: Jan 2010

Posts: 324

Likes: 3

From: los angeles

trans problems

ok i bled the cltuch system and it still goes all of the way down and i can move the fork around(if thats relvant) and i have replaced the master and slave

Nov 6, 2010 | 06:34 PM

farberio

NASA-MW ST4

iTrader: (7)

Joined: Dec 2004

Posts: 3,800

Likes: 3

From: Norcal, Bay Area

The fork should not be able to be moved by hand when the trans is installed. You will have to pul the trans and see what happened.

Nov 6, 2010 | 07:30 PM

fc323

Thread Starter

Senior Member

Joined: Jan 2010

Posts: 324

Likes: 3

From: los angeles

so what could the problem be?

Nov 6, 2010 | 10:08 PM

Black Knight RX7 FC3S

Turbo power, activate!

iTrader: (7)

Joined: Nov 2002

Posts: 1,708

Likes: 6

From: Philadelphia

the fork moving around?
or is it just moving back and forth?
Get another person to look at the slave cylinder when you step down on the clutch and see if it pushes against the fork.

Nov 6, 2010 | 11:40 PM

fc323

Thread Starter

Senior Member

Joined: Jan 2010

Posts: 324

Likes: 3

From: los angeles

well it moves back and forth and side to die too
and i can push the slave back in like when its brand new and ur just compresing the spring to install

Nov 6, 2010 | 11:49 PM

farberio

NASA-MW ST4

iTrader: (7)

Joined: Dec 2004

Posts: 3,800

Likes: 3

From: Norcal, Bay Area

The fork may have popped off its mount. That would cause it to be all wiggly.

Nov 7, 2010 | 01:02 AM

Black Knight RX7 FC3S

Turbo power, activate!

iTrader: (7)

Joined: Nov 2002

Posts: 1,708

Likes: 6

From: Philadelphia

is there tension on the slave cylinder when you push the shaft inside the slave.
If the fork did come off, you can usually pop it back into the ball joint without taking the trans off.