2nd Generation Specific (1986-1992) 1986-1992 Discussion including performance modifications and technical support sections.

Trannsmission help

Thread Tools
 
Search this Thread
 
Old May 17, 2009 | 01:09 AM
  #1  
awddrift4's Avatar
Thread Starter
This.. is my BOOMSTICK!
 
Joined: Oct 2008
Posts: 240
Likes: 0
From: Colorado Springs
Trannsmission help

well to start off, i did a transmission swap. well i ended up getting an S4 tranny for cheap. but i have an S5. we didn't realize it was s4 til after i bought it. is the S5 transmission wiring different from the S4? well i had to change out tail pieces to get the transmission in, but now the starter doesn't click.

i'm betting i miswired it, and i don't have any wiring diagrams, and don't know if the transmission being S4 has anything to do with it.

just wondering if anyone has any Wiring Diagrams for the transmission, and could tell me what the 2 green wires coming out of the neutral switch would hook up to. i have 2 blue wires coming from a switch that i think goes to the ECU, but i have no clue, my Haynes manual and FSM haven't really given me any help on this. i can try to get a pic on tomorrow if you guys have no clue what i am talking about.

thank you
Reply
Old May 17, 2009 | 01:25 AM
  #2  
REPU_74's Avatar
Rotary Enthusiast
iTrader: (12)
 
Joined: Mar 2009
Posts: 1,199
Likes: 0
From: tha SGV 626
is it 5spd or auto????the main wires u need to hook up is the main power and the little female plug connector.the other wires should be the reverse lights...
Reply
Old May 17, 2009 | 01:27 AM
  #3  
awddrift4's Avatar
Thread Starter
This.. is my BOOMSTICK!
 
Joined: Oct 2008
Posts: 240
Likes: 0
From: Colorado Springs
its a 5 speed.

and i forgot to add that the starter doesn't click, or try to turn over. and roll starting doesn't work either. =[
Reply
Old May 17, 2009 | 01:40 AM
  #4  
REPU_74's Avatar
Rotary Enthusiast
iTrader: (12)
 
Joined: Mar 2009
Posts: 1,199
Likes: 0
From: tha SGV 626
the s5 starter is small than the s4,so u might need the s4 one...
Reply
Old May 17, 2009 | 01:53 AM
  #5  
jagass's Avatar
Full Member
 
Joined: Apr 2009
Posts: 72
Likes: 0
From: new jersey
Don't do things that you are not sure of...
Reply
Old May 17, 2009 | 11:02 AM
  #6  
awddrift4's Avatar
Thread Starter
This.. is my BOOMSTICK!
 
Joined: Oct 2008
Posts: 240
Likes: 0
From: Colorado Springs
Originally Posted by WhiteRice_7
the s5 starter is small than the s4,so u might need the s4 one...
Bolted up the same.

i just need help finding a wiring guide. i can take it from there

Originally Posted by jagass
Don't do things that you are not sure of...
We wouldn't get anywhere in the world if we didn't.. just taking that step out there to increase my knowledge
Reply
Old May 17, 2009 | 11:08 AM
  #7  
SpikeDerailed's Avatar
This sh*t burns oil!
Tenured Member: 15 Years
iTrader: (7)
 
Joined: Oct 2006
Posts: 1,239
Likes: 5
From: Charlotte, NC - USA
Did you make sure to reconnect the large ground that bolts up to the bellhousing of the trans? When I swapped out a bad trans I forgot it and the started solenoid wouldnt even click.
Reply
Old May 17, 2009 | 11:33 AM
  #8  
awddrift4's Avatar
Thread Starter
This.. is my BOOMSTICK!
 
Joined: Oct 2008
Posts: 240
Likes: 0
From: Colorado Springs
Originally Posted by SpikeDerailed
Did you make sure to reconnect the large ground that bolts up to the bellhousing of the trans? When I swapped out a bad trans I forgot it and the started solenoid wouldnt even click.
i can go re-check, cause when i turn the key, all i hear is the fuel pump going, and no attempt from the starter.
Reply
Old May 17, 2009 | 12:10 PM
  #9  
awddrift4's Avatar
Thread Starter
This.. is my BOOMSTICK!
 
Joined: Oct 2008
Posts: 240
Likes: 0
From: Colorado Springs
What i'm trying to look for is the wiring setup for the Neutral Switch, the 5th/Reverse Switch and the Starter. i [Finally] found a S5 Wiring Diagram book i'm going through at the moment http://www.whoistouching.us/rx7/s5wiring/ after loads of searching thru threads from the Archives.
Reply
Old May 17, 2009 | 08:44 PM
  #10  
awddrift4's Avatar
Thread Starter
This.. is my BOOMSTICK!
 
Joined: Oct 2008
Posts: 240
Likes: 0
From: Colorado Springs
AHH still can't get the starter to click!
i can tell something isn't wired right, but i need to know what.

Can anyone post up a picture underneath their car showing the wiring from the starter and the tranny? i want my car to finally run, i've felt like a big chunk of me is missing
Reply
Old May 17, 2009 | 10:08 PM
  #11  
farberio's Avatar
NASA-MW ST4
Tenured Member: 20 Years
iTrader: (7)
 
Joined: Dec 2004
Posts: 3,800
Likes: 3
From: Norcal, Bay Area
Did you double check that ground wire, I did the same thing spike did one time.
Reply
Old May 17, 2009 | 11:16 PM
  #12  
awddrift4's Avatar
Thread Starter
This.. is my BOOMSTICK!
 
Joined: Oct 2008
Posts: 240
Likes: 0
From: Colorado Springs
i can post up pictures of what my wiring looks like tomorrow
Reply
Old May 18, 2009 | 09:08 PM
  #13  
awddrift4's Avatar
Thread Starter
This.. is my BOOMSTICK!
 
Joined: Oct 2008
Posts: 240
Likes: 0
From: Colorado Springs
lol i missed 1 wire... and it screwed everything up. its finally running again =D
Reply
Old Mar 20, 2010 | 02:46 AM
  #14  
chancesfold's Avatar
Junior Member
Tenured Member 10 Years
 
Joined: Nov 2009
Posts: 18
Likes: 0
From: Chesapeake, VA
That always happens...
Reply
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
Rickyyp
New Member RX-7 Technical
2
Oct 7, 2010 11:13 AM
tookwik
3rd Generation Specific (1993-2002)
23
Apr 26, 2005 12:17 AM
rx7joe
2nd Generation Specific (1986-1992)
3
Apr 17, 2005 06:16 PM




All times are GMT -5. The time now is 03:08 AM.