I was looking around ACT's website and i didnt see anything on there. Somebody still have these on hand? This is for a TII clutch as well.

-Brendan

 

yeah, its in hte FSM under manual transmission.
that should be the same (thats what i tourqued my ACT stuff to. factory specs)
hope thats what your looking for.

 

do you want to know how much torque it will hanlde before slipping?

 

^I'm referring to pressure plate bolt torque


Yeah i thought that they had their own special torque specs. I ran this same pressure plate when i first went to the 3 rotor I cant remember what i did for torque specs but the clutch had a hard time releasing the disc. It made getting into gear damn near impossible

 

oh, he he, guess i didnt really "read" into what he was writing.
that makes sense then.

 

ah, okay then.
yeah, i just use the factory specs for all that stuff.
im not sure if there would be much difference even if they had their own torque specs. i think the pplate to flywheel bolts are only like 25 ft. lbs right off hand.
but that could be very wrong. so, i dont know what else to say to help.