anyone know what the torque specs should be for the bolts that go to the intake manifold..i had to remove it in order to access the fuel injectors...thanks

 

According to the Haynes manual, the torque spec. is 14 to 19 foot-pounds for the intake manifold to engine bolts. If it were me, I would use Loctite and go about 22 ft-lb to make up for the friction on the less-than-perfect threads of an older engine

 

just go until it feels funny then back off a bit

 

i thought there was an specific order in wich to tighten the bolts

 

Get a FSM or Haynes manual.