I'm trying to find some torque specifications in the FSM but am coming up short. This is for a 1988 n/a, and I'm looking for the torque specs for the LIM to the block, UIM to the LIM, UIM to the dynamic chamber, and TB to the dynamic chamber if there is one. I've looked in the fuel and emissions control for n/a as well as engine and some various other pages but can't find the info I'm looking for.

Can anyone tell me which category and even page (if you know, otherwise just the category) these would be under?

Thanks for any help.

 

run 'em all in 'till they feel good

i think most of the intake stuff is about 10-12 lbs or so... doesn't need to be really tight--just enough to hold vacuum and not work itself loose

 

I wanted to torque them to factory spec. IIRC the UIM to LIM is 14-19 ft/lbs, but I don't remember exactly, plus I don't remember the rest. I'd just rather do it to factory specs so I know I'm doing it enough but not too tight.

 

you are right its 14-19 ft lbs

its in teh first section
engine then assembly then nonturbo. page 79

 

Thanks a bunch! Much appreciated. I knew I had seen it in there before but for some reason I couldn't find it.