Took off my acv today
#1
Full Member
Thread Starter
Join Date: Jul 2002
Location: mass
Posts: 147
Likes: 0
Received 0 Likes
on
0 Posts
Took off my acv today
Hello,
I have an 88 tII (120,000) and today I removed the acv and put the blockoff plate on, I also installed the dual pulley I got from Bonzaitoyota.
I recently put in braided oil cooler lines but before that the lines got everything soaked in oil.I degreased my turbo it was covered in oil.
I want to install my hks BOV but need to get some silicone wires and get rid of all the hard cracked ones.
With the ACV removal and BOV i need to know what and how do i T correctly where they go.
I also have the Racing Beat full 3" exhaust w/fcd.
Benny
I have an 88 tII (120,000) and today I removed the acv and put the blockoff plate on, I also installed the dual pulley I got from Bonzaitoyota.
I recently put in braided oil cooler lines but before that the lines got everything soaked in oil.I degreased my turbo it was covered in oil.
I want to install my hks BOV but need to get some silicone wires and get rid of all the hard cracked ones.
With the ACV removal and BOV i need to know what and how do i T correctly where they go.
I also have the Racing Beat full 3" exhaust w/fcd.
Benny
#4
Queer
Join Date: Mar 2001
Location: Formerly in the Ass end of the pacific.
Posts: 742
Likes: 0
Received 0 Likes
on
0 Posts
For BOV's, EBC's (Electronic Boost Controllers), MAP sensors, etc., they can all be hooked up to any solid vacuum source. You can "T" off of any hose from the upper intake manifold or if you happen to have an extra one just hook it right up to it. The best results will be a direct hook up but T'ing them off of the pressure sensor line will work fine.
Thread
Thread Starter
Forum
Replies
Last Post