TII has no power, plz help
#1
f gi chokes
Thread Starter
Join Date: Jan 2002
Location: Quad Cities
Posts: 410
Likes: 0
Received 0 Likes
on
0 Posts
TII has no power, plz help
I have an 87 TII and it lacks a crapload of power and backfires like hell when i let off the gas. It started after I took my vaf, intake piping and intercooler off. I put everything back together correct, unless I didn't notice some tiny *** vacuum line or something. After that, I went to drive home and about 30 seconds after driving it, it just lost all power, it could barely make it up hills. It also takes forever to rev up. I checked everything again two times after that. My injectors leak really bad when the car sits. Could it be my injectors not spraying right? I also checked everything with my ignition. Anyone have any thoughts?
#4
SOLD THE RX-7!
Join Date: Mar 2001
Location: Vancouver, BC, Canada
Posts: 7,451
Likes: 0
Received 0 Likes
on
0 Posts
you didn't put it back on correct...
check the TID between the turbo and AFM. make sure the AFM is pluged in. take off the IC piping and make sure it's on tight. make sure both vac lines going into the IC are there.
as well as the one going into the TID with the check vavle
check the TID between the turbo and AFM. make sure the AFM is pluged in. take off the IC piping and make sure it's on tight. make sure both vac lines going into the IC are there.
as well as the one going into the TID with the check vavle
#6
Back from teh deadly!
Join Date: Feb 2001
Location: Louisville KY 40299
Posts: 1,163
Likes: 0
Received 0 Likes
on
0 Posts
Originally posted by Scott 89t2
you didn't put it back on correct...
check the TID between the turbo and AFM. make sure the AFM is pluged in. take off the IC piping and make sure it's on tight. make sure both vac lines going into the IC are there.
as well as the one going into the TID with the check vavle
you didn't put it back on correct...
check the TID between the turbo and AFM. make sure the AFM is pluged in. take off the IC piping and make sure it's on tight. make sure both vac lines going into the IC are there.
as well as the one going into the TID with the check vavle
#7
f gi chokes
Thread Starter
Join Date: Jan 2002
Location: Quad Cities
Posts: 410
Likes: 0
Received 0 Likes
on
0 Posts
I checked the vacuum lines, they're all in the right spot and they're all there. The intake is put on right. The problem still remains. Any other ideas? I have injectors coming in a day, hopefully that's it.
Trending Topics
#10
my fc broke
Join Date: Feb 2003
Location: rohnert park,CA/ bay area
Posts: 2,231
Likes: 0
Received 0 Likes
on
0 Posts
sounds like a vacume leak because if the leak is at the tid it will still run fine but idle like shiznit. i know my ran and boosted fine when i had hole in my tid and when it was coming off. it just idled like crap
Thread
Thread Starter
Forum
Replies
Last Post
rotor_veux
2nd Generation Specific (1986-1992)
7
08-31-15 07:49 PM
KAL797
Test Area 51
0
08-11-15 03:47 PM