throttle cable
03-15-04, 02:59 AM
#1
EIT
Thread Starter
Join Date: Jan 2002
Location: Austin, TX
Posts: 1,790
Likes: 0
Received 0 Likes
on
0 Posts
throttle cable
I'm puttin the car back together, and I've had a brain fart or maybe just because it's 3am here. I'm trying to put the throttle and cruise control cables back onto the rod that splits the upper intake. I have 2 brackets, 2 springs, a spacer that slids onto the rod and a nut.
How are the coiled springs connected to the brackets and the rod?
If anyone can take a picture of the stock linkage with the IC off so I can see that should perfect. Thanks.
How are the coiled springs connected to the brackets and the rod?
If anyone can take a picture of the stock linkage with the IC off so I can see that should perfect. Thanks.
03-15-04, 03:16 AM
#2
The Throttle Cable Is furthest out to the Firewall, awhile the Cruise Control Cable Is the one closest to the Plenium.
Depress the Throttle down and simutaneously grab the latch (to the rear) and hook It going from over the assembly and binding at the end of the latch which ends at the bottom. Release the Throttle Plunger and It'll stay. Besure to sandwich the rubber grommet b'n the bracket thats mounted to the Plenium and tighten the Cables accordingly via the FSM specs.
Depress the Throttle down and simutaneously grab the latch (to the rear) and hook It going from over the assembly and binding at the end of the latch which ends at the bottom. Release the Throttle Plunger and It'll stay. Besure to sandwich the rubber grommet b'n the bracket thats mounted to the Plenium and tighten the Cables accordingly via the FSM specs.
I better get used to this than. I've got to remind myself to stomp on your tail when you set yourself up again as you always do. 
Thread
Thread Starter
Forum
Replies
Last Post