For those who have removed OMP...
#1
Rotary Enthusiast
Thread Starter
For those who have removed OMP...
What size bolts did you use to block off where the oil injectors went and where did you buy them?
I hear 10mm x 1.0 , 10mm x 1.25, ive even seen M8 and M10 fastners that look like they would fit. WHICH IS IT IM SO CONFUSED
I hear 10mm x 1.0 , 10mm x 1.25, ive even seen M8 and M10 fastners that look like they would fit. WHICH IS IT IM SO CONFUSED
#3
Rotary Enthusiast
Thread Starter
#4
Rotary Enthusiast
Thread Starter
I think the ones I currently have are 10 x 1.25 .. but they are 30mm long Since they dont seat fully i think they are causing a pretty bad vacuum leak.
DOH i just realized the ones posted above are 1.5mm thread pitch. 1.25 is what i need.. i think
DOH i just realized the ones posted above are 1.5mm thread pitch. 1.25 is what i need.. i think
Last edited by 88 SE; 01-06-03 at 02:25 AM.
#5
Rotary Enthusiast
Thread Starter
Thread
Thread Starter
Forum
Replies
Last Post
Erosangel
3rd Generation Specific (1993-2002)
5
09-18-15 04:06 PM