Hey all, This summer I might be working ona track car to take to PIR (Portland Intl. Raceway). I wanted to brake down the mods that I have and see what you all think.
Engine
S5 block
Lightend S5 rotors
Large Street Port w/ Agressive Port Timing
Hardend Stationary Gears
Deep Grove Rotor Bearings
Pineapple Racing Stage 3 Oil Mods
Counter Weights Lightend to Match Rotors

Intake Exhaust & Ignition
S5 Intake and Dynamic Chamber
Polished and Port Matched Intake
Cone Air Filter
Custom Cold Air Box
RPM Switch Activated 6 Ports and VDI
Pineapple Racing 6 Port Sleeves
RB Road Race Header Collected
Borla XR-1 Sportman
Corksport Generic Muffler (still need to for noise compliance)
Stainless Seel 2.5inch tubing
S-AFC -> MicroTech EMS
8.5mm Plug Wires
MSD 6A Ignition (Leading)
MSD Blaster SS Coils

Drive Line
9lb Flywheel
Street Strip Pressure Plate
Lightend Pressure Plate
Pineapple Racing Race Clutch

 

very nice, got a lot invested in the driver, as well?

 

If you mean me the driver, I don't have any car racing expeirience, but I have done some classes at this track on my motor cycle. But I am scared about totaling the bike since it is a highly modded (most of all the mods are custom one off's) so I don't want to destroy it.
And this build would be very gradual

 

sounds great what kind of track racing is it going to be??

 

Sounds pretty sweet. Is the raceway their just a 1/4 mile strip?

 

There is a 1/4 mile strip, and all of its run off serves as the front straight. But it is a 9 turn road corse, the CHAMP (Indy) cars come here, not sure if they will be here this year.