testing secondary injectors
#4
I R SAD PANDA W/O BAW
You can pull them and flow test them like it says in the FSM. Also put a negative and positive lead to each injector to make sure they click. Dont leave the wires on the terminals long. Just a split second is enough to check if they can fire.
If you already have them out and you can confirm they click then you might as well send them to get cleaned and blueprinted.
If you already have them out and you can confirm they click then you might as well send them to get cleaned and blueprinted.
Thread
Thread Starter
Forum
Replies
Last Post
trickster
2nd Generation Specific (1986-1992)
25
07-01-23 04:40 PM
Skeese
Adaptronic Engine Mgmt - AUS
65
03-28-17 03:30 PM