Testing 5V on ECU connections ?
Thread Starter
Full Member
Joined: Sep 2003
Posts: 107
Likes: 0
From: Savannah, GA
Testing 5V on ECU connections ?
I was reading FAQ section on testing the BAC. They suggest
testing the ECU by jumping the leads at the connector
with a 1/4 ohm resistor, and the results should be about
5V. Is this true for all sensor connectors, like TPS, Oxygen, Pressure, Angle? And what about switches?
testing the ECU by jumping the leads at the connector
with a 1/4 ohm resistor, and the results should be about
5V. Is this true for all sensor connectors, like TPS, Oxygen, Pressure, Angle? And what about switches?
Thread
Thread Starter
Forum
Replies
Last Post
trickster
2nd Generation Specific (1986-1992)
25
Jul 1, 2023 04:40 PM
Skeese
Adaptronic Engine Mgmt - AUS
65
Mar 28, 2017 03:30 PM