Temp Gauge Not Working...HELP!!!
#1
Don't speak anymore...
Thread Starter
Join Date: Jan 2006
Location: Tally-No, FL
Posts: 471
Likes: 0
Received 0 Likes
on
0 Posts
Temp Gauge Not Working...HELP!!!
Ok as simple as this probably is my temp gauge on my GTU is not working and I cannot find where the issue is. I am under the assumption it is the Temp Sending Unit that is not sending a signal to the Temp Gauge. Can anyone give a helping hand to a lost soul?
Where should I be looking since the cluster is working in regards all other gauges...?
What should I be looking for to be wrong...?
How do I go about correcting the issue...?
ThanX,
Dustin
Where should I be looking since the cluster is working in regards all other gauges...?
What should I be looking for to be wrong...?
How do I go about correcting the issue...?
ThanX,
Dustin
#3
Don't speak anymore...
Thread Starter
Join Date: Jan 2006
Location: Tally-No, FL
Posts: 471
Likes: 0
Received 0 Likes
on
0 Posts
Yea its plugged in... The shell is broken up but it's still plugged in. Is there a way to re-route or re-configure the wires to make this thing work? LOL
#5
Don't speak anymore...
Thread Starter
Join Date: Jan 2006
Location: Tally-No, FL
Posts: 471
Likes: 0
Received 0 Likes
on
0 Posts
Right I hear you on that one my only concern is this... How do I know it's the sender itself? If it's crappy wiring then what should I look for? I don't wanna start tearin stuff apart and then be stuck trying to figure out how to rewire crap...
Thread
Thread Starter
Forum
Replies
Last Post
Adaptronic 1280s Hot Start 3 Rotor 20b RX7
Monsterbox
Adaptronic Engine Mgmt - AUS
5
09-11-15 03:29 PM