I read the instructions from kevins site but i dont currenly have a na harness to reference. Does anyone have any pics or a diagram on how to wire this correctly?

 

the only refereance is the factory service manual. Links for the factory service manuals are found in the FAQ for FC sticky thread found at the top of this section

 

There are two plugs on the Emission harness that mate with the Front harness. On a 87 they have ref designators X-16 and X-16. In the 88 manual they are called FEM-01 and FEM-02 respectively.

That is where SOME people have to alter the turbo emissions harness that they are mating with a non turbo Front harness.

Attached is a jpg of the two sides of each plug, X-15 and X-16.

The wires/sockets that are different b/t the turbo and non turbo are shown as (*).

It helps to know what a particular wire does in life. YOu can figure that out by looking at the schematics.

Personally I'd never put a turbo emissions harness in a non turbo car. Too much fiddling around IMHO. Even though if you use a non turbo harness for the swap you'd still end up moving wires around, like for the knock box, twin scroll solenoid etc. Done

https://www.rx7club.com/forum/attach...hmentid=142663

 

Thanks Hailers