t04b boost and fuel
#1
mmmtrbo.
Thread Starter
Join Date: Aug 2002
Location: SF BAY AREA
Posts: 682
Likes: 0
Received 0 Likes
on
0 Posts
t04b boost and fuel
Alright, I bought a Garrett T04b the other day. .60 a/r
I have 2.5 dual n1's, tid, streetport, and some other goodies. Anyways, my fuel setup right now is 550cc pimaries, 720cc secondaries, RP fuel pump, FCD, and SAFCII. Once my rebuild and break-in is complete, I will have access to a dyno. I was thinking about running 680cc pimaries, but money is a little low right now. Also, I know I need to go front mount, that will be later. So, my question is, what boost can I run safely with my current setup?
Thanks,
Ben
I have 2.5 dual n1's, tid, streetport, and some other goodies. Anyways, my fuel setup right now is 550cc pimaries, 720cc secondaries, RP fuel pump, FCD, and SAFCII. Once my rebuild and break-in is complete, I will have access to a dyno. I was thinking about running 680cc pimaries, but money is a little low right now. Also, I know I need to go front mount, that will be later. So, my question is, what boost can I run safely with my current setup?
Thanks,
Ben
#2
Learned alot | Alot to go
iTrader: (2)
Join Date: Apr 2002
Location: Rotaryland, New Hampshire
Posts: 4,232
Likes: 0
Received 0 Likes
on
0 Posts
Im not sure for boost, but i 'think' that the injector's you are using are aonly good for 300hp max
Also, if your talking .6 a/r on the hotside, that is rather small for a rotary application, iirc, most people here dont go smaller than a .8, again, i could be wrong
-Jacob
Also, if your talking .6 a/r on the hotside, that is rather small for a rotary application, iirc, most people here dont go smaller than a .8, again, i could be wrong
-Jacob
Thread
Thread Starter
Forum
Replies
Last Post
Skeese
Adaptronic Engine Mgmt - AUS
65
03-28-17 03:30 PM