2nd Generation Specific (1986-1992) 1986-1992 Discussion including performance modifications and technical support sections.

Symptoms of a bad tranny/diff mounts?

Thread Tools
 
Search this Thread
 
Old Apr 7, 2006 | 06:31 PM
  #1  
DASUPACAT1's Avatar
Thread Starter
Senior Member
Tenured Member 05 Years
 
Joined: Jul 2005
Posts: 603
Likes: 0
From: FORT WAYNE
Symptoms of a bad tranny/diff mounts?

Well lately every time I shift I hear a metallic thump/clunk from under the car. This happens when I let off the clutch after the car has been put into the gear I select. Is there any way to tell by doing a visual inspection? What should I look for? Are the mounts hard to replace? I'm doing an engine oil/diff oil change tomorrow so I'll be under the car to look.
Reply
Old Apr 7, 2006 | 09:43 PM
  #2  
DASUPACAT1's Avatar
Thread Starter
Senior Member
Tenured Member 05 Years
 
Joined: Jul 2005
Posts: 603
Likes: 0
From: FORT WAYNE
Anyone?
Reply
Old Apr 8, 2006 | 01:21 AM
  #3  
Black91n/a's Avatar
Lives on the Forum
Tenured Member 10 Years
 
Joined: Sep 2003
Posts: 5,707
Likes: 6
From: BC, Canada
Is it while you're letting the clutch out that you hear the noise, or after, once you start accelerating again? Is there some jerkyness associated with the noize? If it's after the clutch is engaged and when you get back on the gas it's probably a diff mount. If it's from the rear then definetely check the front diff mount, as it's known to break and cause a metallic clunking sound. Other than that it could be an engine or transmission mount, but that's unlikely.
Reply
Old Apr 8, 2006 | 05:06 AM
  #4  
DASUPACAT1's Avatar
Thread Starter
Senior Member
Tenured Member 05 Years
 
Joined: Jul 2005
Posts: 603
Likes: 0
From: FORT WAYNE
A little of both. There is some jerkiness too.
Reply
Old Apr 8, 2006 | 10:12 AM
  #5  
Syncro's Avatar
Buildup Thread Encourager
Tenured Member: 20 Years
iTrader: (1)
 
Joined: Jun 2005
Posts: 1,170
Likes: 0
From: Miami, FL
Check the u-joints on the driveshaft, too.
Reply
Old Apr 8, 2006 | 10:15 AM
  #6  
73828793's Avatar
went RX crazy............
Tenured Member 05 Years
 
Joined: Jul 2004
Posts: 211
Likes: 0
From: Vineland, New Jersey
clunking during gear changes like reverse etc... is diff mount. usually when the trans mount starts going bad you will get vibrations inside the car when you rev the engine, even in neutral.
Reply
Old Apr 8, 2006 | 11:45 AM
  #7  
rxspeed87's Avatar
Rotary Enthusiast
Tenured Member 10 Years
 
Joined: Mar 2001
Posts: 968
Likes: 0
From: Caldwell,ID
clunk. clunk jerk jerk

sounds like a diff mount to me. I have the same problem


real easy to figure out go under the car and reach up to the front snout of the differential and push up. watch if move up fairly easily.



problem is it shouldn't
Reply
Old Apr 8, 2006 | 12:29 PM
  #8  
DASUPACAT1's Avatar
Thread Starter
Senior Member
Tenured Member 05 Years
 
Joined: Jul 2005
Posts: 603
Likes: 0
From: FORT WAYNE
well it seems after i shift into and out of a gear like 1st to 2nd then into 3rd as soon as I let off the clutch and get on the gas is when the clunk happens.
Reply
Old Jun 20, 2006 | 04:18 PM
  #9  
-Ryan-'s Avatar
Full Member
Tenured Member 05 Years
 
Joined: Feb 2006
Posts: 126
Likes: 0
From: North Carolina
have you fixed your issue...
I have the same issues and have pinpointed the front diff. mount..
I have a thread on it today...

I would like to find a write up on how to replace it... what have you done?
Reply
Old Jun 20, 2006 | 04:58 PM
  #10  
socalrotor's Avatar
Rotary Freak
Tenured Member 15 Years
iTrader: (1)
 
Joined: Mar 2003
Posts: 2,839
Likes: 0
From: southbay
There is a sticky on the FAQ if I recall correctly!
EDIT*****

https://www.rx7club.com/2nd-gen-archive-72/easy-way-change-diff-mount-39026/

Last edited by socalrotor; Jun 20, 2006 at 05:01 PM.
Reply
Old Jun 20, 2006 | 05:08 PM
  #11  
-Ryan-'s Avatar
Full Member
Tenured Member 05 Years
 
Joined: Feb 2006
Posts: 126
Likes: 0
From: North Carolina
Thanks man.. you always pull through..
Could you look at my thread that I started today to see pics of my situation and verify its a broken front diff mount

https://www.rx7club.com/showthread.p...9&page=1&pp=15
Reply
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
MazdaAspec
3rd Generation Specific (1993-2002)
6
Sep 9, 2015 02:04 PM
86glxNA
New Member RX-7 Technical
7
Aug 22, 2015 08:54 PM
Wolf_
Single Turbo RX-7's
3
Aug 11, 2015 04:23 PM




All times are GMT -5. The time now is 12:07 AM.