Swapping motors... need help
#1
Full Member
Thread Starter
Join Date: Aug 2004
Location: Dublin, CA
Posts: 135
Likes: 0
Received 0 Likes
on
0 Posts
Swapping motors... need help
I am doing a motor swap on my 10th AE, i am removing the blown motor and putting in a slightly used JSPEC one. The problem is, the JSPEC one didn't come with any externals. Long story short, I need gaskets. Is there any other place other than a mazda dealership that I can get them? I have spent countless hours on the internet searching but can't find a good place. Any help would be appreciated.
Shaun
Shaun
#3
Passing life by
Why do you need gaskets? You can pull the motor fine without removing the UIM.
Go to auto zone spend $5 and get a DIY gasket sheet trace the part you need on it and cut it out with a razor or exzacto knife.
Go to auto zone spend $5 and get a DIY gasket sheet trace the part you need on it and cut it out with a razor or exzacto knife.
Thread
Thread Starter
Forum
Replies
Last Post
Jeff20B
1st Generation Specific (1979-1985)
73
09-16-18 07:16 PM
gtcd
1st Generation Specific (1979-1985)
3
09-17-15 01:15 PM
gabescanlon
3rd Generation Specific (1993-2002)
2
09-15-15 06:57 AM
jakeishness
2nd Generation Specific (1986-1992)
11
09-11-15 11:33 AM