swapping ehaust port sleeves, got a ?
#1
Engineering Student
Thread Starter
Join Date: May 2005
Location: Tennessee Tech University
Posts: 414
Likes: 0
Received 0 Likes
on
0 Posts
swapping ehaust port sleeves, got a ?
aight, im swapping the exhaust port sleeve from a TII housing to one of my N/A ones for my rebuild, i know i can drill the pin out and take it out, but you do i get it back in, do i just get an aluminum pin to hold it in?
thanks
Dennis
thanks
Dennis
#3
Rotary Enthusiast
iTrader: (9)
good luck drilling it out, the roll pins are hardened steel. if you have access to a welder weld the filler rod to the pin. then get some pliers and pull the pin out using the filler rod. as for securing the new sleeves, most hardware stores should have roll pins.
Thread
Thread Starter
Forum
Replies
Last Post
Azevedo
Other Engine Conversions - non V-8
26
03-01-19 09:19 PM