strong bouncing idle after hard pull ping rich
Junior Member
Joined: May 2010
Posts: 39
Likes: 0
From: Seattle, WA
never had a bouncing idle caused by anything but a TPS( 10% of the time), or a vacuum leak(90% of the time). sounds like boost blew a line or a nipple off.
do you have paper or metal intake gaskets?( or maybe just silicon?)
Paper or silicon, i would check there also. or do a intake pressure test, as these dont seem to expensive to get the parts to do. just some homedepot fittings, guage, and some soap and water.
do you have paper or metal intake gaskets?( or maybe just silicon?)
Paper or silicon, i would check there also. or do a intake pressure test, as these dont seem to expensive to get the parts to do. just some homedepot fittings, guage, and some soap and water.
There is no such thing as "common vacuum leaks". If there is, it would be were you commonly forget to hook up lines...
A pulsing idle is typically a vacuum leak, a few things to check:
Throttle cable for seizing, needs to returning completely
Turbo inlet duct for cracks
All couplers and clamps on intercooler
BOV for leaks, especially if it is aftermarket
Check your boost sensor, if the voltage is screwy it can tell the ECU all kinds of bad info
Throttle cable for seizing, needs to returning completely
Turbo inlet duct for cracks
All couplers and clamps on intercooler
BOV for leaks, especially if it is aftermarket
Check your boost sensor, if the voltage is screwy it can tell the ECU all kinds of bad info
Joined: Mar 2004
Posts: 287
Likes: 0
From: Los Angeles, CA
bouncing idle can be vacuum leak. one reason its more likely a vacuum leak instead of a tps: it started after you did a hard pull.
im going to guess that boost pressure blew off a vacuum line.
im going to guess that boost pressure blew off a vacuum line.
Thread
Thread Starter
Forum
Replies
Last Post
alphawolff
1st Generation Specific (1979-1985)
17
Nov 17, 2015 05:57 PM
