yesterday i replaced my oil pressure sending unit thinking that it would make my oil pressure gauge work... nope.

its like its not even hooked up.

 

hmm, is it hooked up?

 

indeed it is hooked up.

 

well is it hooked up?

 

Hey, how's it goin, Logan? I've begun rebuilding that tranny I got from ya, from what I've seen so far I seriously doubt it had been rebuilt when the guy said it did, but it'll be awright!

Jacobcartmill, is that capacitor for your sending unit bolted to the clutch slave? Although I'm not sure if that would make it inop or not...
Follow the wire from the sending unit down to the harness- look good so far?

 

hey wayne... just wanted to ask, does anything look broken? anything chipped? good thing you're rebuilding it!

i know when my gauge wasn't working, the wire was just disconnected... it also looked pretty flimsy to me...

 

I haven't got the "guts" out of her yet, that'll be in a couple of days, but just seeing the front seal, tranny front cover throwout bearing shaft & fork arm pivot (very worn), and all the bushing trash in the shifter tower, I'd say it's been a while since anybody's gave her any attention...

Jacob- that sender needs a good ground via its threads also, you didn't wrap a bunch of teflon tape around it, did ya?