Stepper motor? listed on wiring diagram but not in index?
#1
Rotary Enthusiast
Thread Starter
Join Date: May 2005
Location: bartlett IL
Posts: 919
Likes: 0
Received 0 Likes
on
0 Posts
Stepper motor? listed on wiring diagram but not in index?
I dont see this part. I have the 6 pin connector in the body harness, I am stripping every non essential part and running the wires through the frame rails. So I need to know what it is to know if I need to extend it. I searched the posts, I read the manual but it is listed in wiring diagram as "stepper motor" and I cant find it in the index or anywhere else. the plug is near the main underhood fuse block. Any help appreciated.
#6
Rotary Enthusiast
Thread Starter
Join Date: May 2005
Location: bartlett IL
Posts: 919
Likes: 0
Received 0 Likes
on
0 Posts
OK so stepping motor is supposed to be on the power steering pump... but I dont seem to have one? Is it possible that J-spec didn't come with speed sensing power steering?
#7
I'm a boost creep...
Join Date: Jan 2002
Location: Auckland, New Zealand
Posts: 15,608
Likes: 0
Received 8 Likes
on
8 Posts
Your PM said it was an S5 pump. Some S5's came with conventional power steering which has no stepper motor. If the pump only has two lines instead of three then that's what it is.
Trending Topics
#8
Rotary Enthusiast
Thread Starter
Join Date: May 2005
Location: bartlett IL
Posts: 919
Likes: 0
Received 0 Likes
on
0 Posts
Ah I see yes it has only two lines and I dont forsee getting a new RHD rack to change over so I will remove that part of the harness then.Thanks for the patience and help
Thread
Thread Starter
Forum
Replies
Last Post
streetlegal?
New Member RX-7 Technical
13
03-17-22 02:46 PM
befarrer
Microtech
3
08-22-15 05:52 PM