2nd Generation Specific (1986-1992) 1986-1992 Discussion including performance modifications and technical support sections.
Sponsored by:

Starts up good...then dies after 10 mins??

Thread Tools
 
Search this Thread
 
Old 05-04-02, 11:12 AM
  #1  
Full Member

Thread Starter
 
mr. ut's Avatar
 
Join Date: Apr 2002
Location: atlanta
Posts: 129
Likes: 0
Received 0 Likes on 0 Posts
Starts up good...then dies after 10 mins??

went out this morning..car sat all nite...
*Started it up, went straight to 3000 RPMs, ok..GOOD
*Then, progressively went down to a lil below 1000 RPMs. ok..still GOOD
*so, i let it sit for a while...after about 10-15 mins, it jsut dies???

I dont kno what to think, the car started off really well, but then just dies?, what will cause this?,

thank you
Old 05-04-02, 12:50 PM
  #2  
Rotary Freak

 
SaabGuy's Avatar
 
Join Date: Oct 2001
Location: Atlanta, GA
Posts: 1,514
Likes: 0
Received 1 Like on 1 Post
Intake air leaks

Fuel supply (bad gas/injectors)

tuneups

in that order
Old 05-04-02, 01:58 PM
  #3  
Full Member

Thread Starter
 
mr. ut's Avatar
 
Join Date: Apr 2002
Location: atlanta
Posts: 129
Likes: 0
Received 0 Likes on 0 Posts
thanks,
if its an intake leak, as in a vacuum leak, wouldnt tha idle be abnormal?, like, bouncy? mines, wen it gets a lil warm, it will be a lil under 1000 RPM, and and be steady, then, after lettin it sit there, it will jsut lose all power and die.

oh well...still trying to diagnos this
Old 05-04-02, 02:31 PM
  #4  
Rotor Head

 
DC350's Avatar
 
Join Date: Jan 2002
Location: British Columbia
Posts: 1,966
Likes: 0
Received 0 Likes on 0 Posts
Run outta gas? hjeheh
Old 05-04-02, 05:16 PM
  #5  
HAILERS

 
HAILERS's Avatar
 
Join Date: May 2001
Location: FORT WORTH, TEXAS,USA
Posts: 20,563
Likes: 0
Received 21 Likes on 19 Posts
Set the timing, tps, and then the idle. You do just fine in the beginning because your thermowax and fast idle cam are keeping the primary throttly plates cracked open approx .016 in. When the water heats up, the thermowax extends , gradually, and when the roller falls off the fast idle cam, the .016 gap goes to zip gap. At this time, if the idle had been set properly, the car would idle at 750 rpm. It does not because the car needs a *tune up*, i.e. the idle set per the manual that is free at http://iluvmyrx7.com its in the FUEL SECTION.
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
rx7shirley
2nd Generation Specific (1986-1992)
6
09-02-15 02:11 PM
ray green
1st Gen General Discussion
2
09-02-15 06:35 AM



Quick Reply: Starts up good...then dies after 10 mins??



All times are GMT -5. The time now is 02:23 PM.