2nd Generation Specific (1986-1992) 1986-1992 Discussion including performance modifications and technical support sections.

starting question

Thread Tools
 
Search this Thread
 
Old Aug 10, 2006 | 07:18 PM
  #1  
dizflyaznboi's Avatar
Thread Starter
Full Member
Tenured Member 05 Years
 
Joined: May 2006
Posts: 104
Likes: 0
From: Grand Prairie
starting question

I have a 86 NA, and its being wierd. When i try to start it, the car doesnt crank. All I hear is a click. So far ive:

I took off my starter and had it tested, and it turned out to be good.

I also had my battery tested today and got 12.5 v.

I did the alternator test thing, where you start the car then take off the positive terminal and if the car stays on then the alternator is still good.

Now im stumped, I know the car runs because i can bump start it, but i cant figure out why it wont start normally. So far my guess is a wire is frayed or something, Can anyone give me a hint to where i can start my search?
Reply
Old Aug 17, 2006 | 04:32 PM
  #2  
geetarstar's Avatar
RXJASON
Tenured Member 15 Years
 
Joined: Nov 2005
Posts: 135
Likes: 0
From: CALIFORNIA
Im in a simular situation as well. All was tested and is fine.. I thought the motor was stuck but I can push start and turn the motor my hand.
Reply
Old Aug 17, 2006 | 11:29 PM
  #3  
R_PROWESS's Avatar
F[x]3S ENG.
Tenured Member: 20 Years
Liked
Loved
Community Favorite
iTrader: (3)
 
Joined: May 2005
Posts: 1,679
Likes: 18
From: Rochester, IN
i had this problem until i mounted my patery in the rear. i found if you dont have a good enough ground (even when you think its good) you lose alot fo voltage to the starter and it just clicks and sticks or just grinds or just does nothing. make sure the negative terminal is as tight as you cna get it also ptu some dialectric on there and clean up both terminals
Reply
Old Aug 18, 2006 | 07:35 AM
  #4  
My5ABaby's Avatar
Rotaries confuse me
Tenured Member 10 Years
iTrader: (7)
 
Joined: May 2006
Posts: 4,219
Likes: 3
From: Murfreesboro, TN
The battery terminal connections probably don't work like they should. I had this problem and it was my battery terminals.
Reply
Old Aug 18, 2006 | 07:50 AM
  #5  
iSP33D-for-J3SUS's Avatar
s4 Tails for Life!
Tenured Member 05 Years
 
Joined: Feb 2005
Posts: 577
Likes: 0
From: Dallas, TX
Talking

This probably sounds really stupid but, are you fully depressing the clutch when you go to start the car? *Assuming you have a 5spd*

iSP33D-for-J3SUS
Reply
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
trickster
2nd Generation Specific (1986-1992)
25
Jul 1, 2023 04:40 PM
Skeese
Adaptronic Engine Mgmt - AUS
65
Mar 28, 2017 03:30 PM
alphawolff
1st Generation Specific (1979-1985)
17
Nov 17, 2015 05:57 PM
lt1_rx7
Blue Ridge Rotary Run
46
Oct 9, 2015 03:11 PM
CaptainKRM
2nd Generation Specific (1986-1992)
14
Aug 26, 2015 09:52 PM




All times are GMT -5. The time now is 11:35 AM.