starting problem!!!
#1
Full Member
Thread Starter
Join Date: May 2003
Location: orlando fl
Posts: 187
Likes: 0
Received 0 Likes
on
0 Posts
starting problem!!!
The car ran fine untill i tried to start it today after it was sitting for a while like an hour or two. It made a fan spinning noise but the engine would not crank the battery is fine and grounds are also. I later had to pust start it and it fired up on the first try. I think it is the starter soloniod but please help
#2
Full Member
Join Date: Nov 2003
Location: Stillwater, Ok
Posts: 124
Likes: 0
Received 0 Likes
on
0 Posts
starter seliniod will make a clicking sound if it works. If not it could just do nothing, or it could get stuck in the on position and continue drawing power from your battery until you have a melt down. if it makes a fan spinning sound it could be a worn starter gear. Its the one that matches up with the gears on the flywheel. Its softer than the metal on the flywheel so it wears out first. starting with a worn starter gear can be hit or miss just depending on what teeth are the most worn where.
hope this helps .
hope this helps .
#3
7s bein a pain in the ass
Join Date: Nov 2003
Location: Chico, CA
Posts: 704
Likes: 0
Received 0 Likes
on
0 Posts
i just recently had the same problem with my 86 na. mine was sitting for a hour or two whilel i was shopping. came back to start and had the same problems you mentioned. i don't know what's wrong with mine either. had it towed home then tried starting it the next morning. it started ok. i am a new rx7 owner so im still in the learning process.
#5
Junior Member
Join Date: Dec 2003
Location: Australia
Posts: 16
Likes: 0
Received 0 Likes
on
0 Posts
Same problem, starter would spin, sometimes it would engage, frequently wouldn't.
Removed starter and took to auto electrician and apparently the bendix is flty. I think that is a centrifical clutch in it. He is rebuilding it for me now. Couldn't get an exchange starter as the only ones available had the smaller pinion gear.
Removed starter and took to auto electrician and apparently the bendix is flty. I think that is a centrifical clutch in it. He is rebuilding it for me now. Couldn't get an exchange starter as the only ones available had the smaller pinion gear.
#6
Full Member
Join Date: Nov 2003
Location: Silverdale, WA
Posts: 67
Likes: 0
Received 0 Likes
on
0 Posts
i sometimes have a starter problem also. used to be if the engine was cold it would barely turn over, and i have to give it quick gas or it will stall. now sometimes when the engine is warm it wont turn over at all, but get very close and you gotta give it gas as its turning to get it to start. not sure what to check though, im guessing my alternator isnt recharging my battery, but other than that i have no idea. maybe my spark plugs (installing new ones as soon as it stops raining) also if it doesnt turn over, if you go to turn it again it makes a horrible grinding sound, and you gotta turn it all the way off and then it will turn over.
Thread
Thread Starter
Forum
Replies
Last Post
trickster
2nd Generation Specific (1986-1992)
25
07-01-23 04:40 PM