Starter Wiring
02-18-04, 11:22 PM
#1
Rest In Peace Dave
Thread Starter
Join Date: Feb 2004
Location: Idaho
Posts: 1,347
Likes: 0
Received 0 Likes
on
0 Posts
Starter Wiring
Okay, so i bought my Rex w/o a tranny in it so now i have got it reassemebled, push started it, and it runs great. Now i finnaly got my starter and just a bit confused where everything goes in the pic i talked to someone a little about it and was told that the wire w/o the boot bolts onto the one of the tranny bolts (4) i was curious to find out if anything acctually bolts onto terminal (1) i know that the small clip goes on terminal (2) and i assume the booted wire goes on terminal (3) just want to double check this for when i install it tomarrow, thanks
02-18-04, 11:25 PM
#2
Eet fase
iTrader: (49)
Join Date: May 2002
Location: Lexington, SC USA
Posts: 1,759
Likes: 0
Received 0 Likes
on
0 Posts
If I remember correctly, #1 is the hot wire, #2 is the switched power, and #3 is the negative terminal. The starter ground goes to a transmission bolt farther up.
02-18-04, 11:49 PM
#4
Eet fase
iTrader: (49)
Join Date: May 2002
Location: Lexington, SC USA
Posts: 1,759
Likes: 0
Received 0 Likes
on
0 Posts
That needs to be grounded. It escapes me what exactly it is for, but I believe it has to do with the clutch slave cylinder. Mine is just underneath one of the bolts on the slave cylinder.
02-19-04, 12:05 AM
#5
Glock Lover
Join Date: Mar 2001
Location: Currently residing in St Charles, MO
Posts: 2,223
Likes: 0
Received 0 Likes
on
0 Posts
1 goes nowhere
2 gets the little clip
3 gets the booted wire.
Put the mystery ring on the bolt that goes through the starter, transmission and rear housing.
2 gets the little clip
3 gets the booted wire.
Put the mystery ring on the bolt that goes through the starter, transmission and rear housing.
Thread
Thread Starter
Forum
Replies
Last Post
toplessFC3Sman
2nd Generation Specific (1986-1992)
6
03-20-18 01:54 PM
Adaptronic 1280s Hot Start 3 Rotor 20b RX7
Monsterbox
Adaptronic Engine Mgmt - AUS
5
09-11-15 03:29 PM