starter issues
#1
Full Member
Thread Starter
Join Date: Jul 2007
Location: Vancouver, Canada
Posts: 95
Likes: 0
Received 0 Likes
on
0 Posts
starter issues
-so i bench tested my starter, it works, but when i put it in the car it doesent,
-i have 12v at the solenoid wire key one cranking position
-and i have 12v at the power wire
-and there is continuity from the neg side of the battery to the started
-it goes through phases of working then not working
-i have 12v at the solenoid wire key one cranking position
-and i have 12v at the power wire
-and there is continuity from the neg side of the battery to the started
-it goes through phases of working then not working
#4
Full Member
Thread Starter
Join Date: Jul 2007
Location: Vancouver, Canada
Posts: 95
Likes: 0
Received 0 Likes
on
0 Posts
if it was a bad ignition switch, why would i get 12volts at the solenoid in the key cranking position
and i tested the starter + the solenoid it all works
and i tested the starter + the solenoid it all works
Thread
Thread Starter
Forum
Replies
Last Post
Adaptronic 1280s Hot Start 3 Rotor 20b RX7
Monsterbox
Adaptronic Engine Mgmt - AUS
5
09-11-15 03:29 PM