2nd Generation Specific (1986-1992) 1986-1992 Discussion including performance modifications and technical support sections.
Sponsored by:

It started!

Thread Tools
 
Search this Thread
 
Old 01-01-09, 02:14 PM
  #1  
magic spinning triangles!
Thread Starter
 
watindes's Avatar
 
Join Date: Dec 2008
Location: Richmond
Posts: 59
Likes: 0
Received 0 Likes on 0 Posts
It started!

I just got this rx7, the fuel pump was not receiving power so I ran a hot line with a fuse and cut off switch my wife helped install. It sat for a year until today, was smokey when started (again sitting for a year) but cleared out, I do know they burn oil by design. The only snafu we had was the rubber fuel line going into the motor sprung a pin hole leak. It has an exhaust leak around the air pump intake on the passanger side (new gasket?). Does it hurt anything to completely take the pump out of the equation and disconnect the belt? It idles smooth and drives well and sounds good, no bubbles in the coolant so no internal leaks. I got the car for $400, no rust, garage kept (has some dings and dents) and a re-built engine with 7500 miles on it. The sellers son died who drove it and he did not want it anymore.
Up next is a fresh oil change and some small parts to get it rad worthy.

Nice forum really helpful,

Jesse
Old 01-01-09, 02:25 PM
  #2  
Full Member
iTrader: (1)
 
Rotary Powah's Avatar
 
Join Date: Nov 2008
Location: Birmingham
Posts: 213
Likes: 0
Received 0 Likes on 0 Posts
Good job getting it started!

No, it won't hurt anything to remove the air pump (It's a mod most people do eventually), except you'll probably fail emissions if you have it in your area
Old 01-01-09, 02:32 PM
  #3  
Manual Rack

iTrader: (50)
 
FelixIsGod29X's Avatar
 
Join Date: Aug 2005
Location: Wanaque NJ
Posts: 3,652
Likes: 0
Received 1 Like on 1 Post
"I got the car for $400, no rust, garage kept (has some dings and dents) and a re-built engine with 7500 miles on it."

You are very very lucky. Take care of it and POST PICS!
Old 01-01-09, 03:18 PM
  #4  
magic spinning triangles!
Thread Starter
 
watindes's Avatar
 
Join Date: Dec 2008
Location: Richmond
Posts: 59
Likes: 0
Received 0 Likes on 0 Posts
Thanks! I believe it is leaking from where the pump connects to the engine , I am not sure what its called. I may disconnect the belt, They all smoke a little on start up that's what I have been hearing because of how the engine is designed. any step by step on how to remove the emissions? I also need a CD player for it, anyone know if these came with factory units?

Thanks

Jesse
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
Jeff20B
1st Generation Specific (1979-1985)
73
09-16-18 07:16 PM
ZacMan
Build Threads
4
09-19-15 09:20 PM
sherff
Adaptronic Engine Mgmt - AUS
5
09-12-15 12:22 PM
whinin
New Member RX-7 Technical
10
09-05-15 11:52 PM



Quick Reply: It started!



All times are GMT -5. The time now is 09:47 PM.