I just replaced my tranny, driveshaft, and rear end, and at first when my car was started it would go into gear unless you pressed the motor against the tranny becuase there wasn't any tranny bolts in the top, so I got the bolts put them in started it and it would go into gear took my car off the jacks started it and it wouldn't go into gear =(, I am so angry right now I haven't been able to drive my TII for a few months now and I thought I finally had it done, so can you guys please try and help me out, maybe someone in the tacoma area could even stop by? I don't know I just want to drive it again,
Thanks, Eric

 

Ok the tranny is bolted to the engine right?

If soo is the rod from the slave placed corectly in the shift fork thingy..lol

 

problem found lol, bolts werent tighten, damn friends not tighten them enough haha