Size of OMP block-off plate?
Thread Starter
Refined Valley Dude
Joined: Oct 2001
Posts: 2,283
Likes: 2
From: Kitchener, Ontario (Hamilton's armpit)
Size of OMP block-off plate?
I found this image of a custom OMP block-off plate this afternoon.
I'm going to yank my OMP this week and all I need is the block-off plate. I plan to have one fab'ed, and I'll need to know what dimensions to give them...
My 7 is an 86 NA.
If someone would kindly Photochop dimensions on top of this image (including thickness,) I can just print it out and fork it over at the shop.
Thanx!
My cars louder than yours
Joined: Oct 2001
Posts: 1,969
Likes: 0
From: Augusta, GA
I dunno the deminsions, but i just slaped the old OMP on there, and it left a grease impression on , and just cut around that ****, pop some holes in it, and sho nuff block block that **** off. Mine was bout 3mm think aluminum, and i think standard is 2mm steel.
Open up! Search Warrant!
Joined: May 2002
Posts: 3,838
Likes: 3
From: Kicking down doors in a neighborhood near you
Originally posted by Roy James
I dunno the deminsions, but i just slaped the old OMP on there, and it left a grease impression on , and just cut around that ****, pop some holes in it, and sho nuff block block that **** off. Mine was bout 3mm think aluminum, and i think standard is 2mm steel.
I dunno the deminsions, but i just slaped the old OMP on there, and it left a grease impression on , and just cut around that ****, pop some holes in it, and sho nuff block block that **** off. Mine was bout 3mm think aluminum, and i think standard is 2mm steel.
Thread
Thread Starter
Forum
Replies
Last Post
Jeff20B
1st Generation Specific (1979-1985)
73
Sep 16, 2018 07:16 PM
[For Sale] Scratch & Dent, Used, and Open-Box Sale!
SakeBomb Garage
Vendor Classifieds
5
Aug 9, 2018 05:54 PM
rx8volks
Canadian Forum
0
Sep 1, 2015 11:02 PM
