Searched, need idle hep, car idles high.
Thread Starter
Junior Member
Joined: Jul 2003
Posts: 23
Likes: 0
From: T.O.
Searched, need idle hep, car idles high.
Followed FSM, every single sensor,switch, plug, plate, screw...you get the point has been checked and is within spec.
car still idles at over 1300 rpm.
wtf.
jspec s5 block, s4 manifolds and sensors, s4 harness modded to fit s5, vac rack intact, s4 afm - level, s4 ecu.
is it possible that the previous owner of the car had drilled out the tb plates to compensate for...porting perhaps?
anybody have any ideas before i take a sledge hammer to the car. Thanks.
car still idles at over 1300 rpm.
wtf.
jspec s5 block, s4 manifolds and sensors, s4 harness modded to fit s5, vac rack intact, s4 afm - level, s4 ecu.
is it possible that the previous owner of the car had drilled out the tb plates to compensate for...porting perhaps?
anybody have any ideas before i take a sledge hammer to the car. Thanks.
Thread
Thread Starter
Forum
Replies
Last Post
trickster
2nd Generation Specific (1986-1992)
25
Jul 1, 2023 04:40 PM
alphawolff
1st Generation Specific (1979-1985)
17
Nov 17, 2015 05:57 PM