Is this a safe igntion table to run boost on?
Im going to try to tune the afr/lamdba this weekend but a want to be sure this table is safe to run base boost levels on?

http://www.vems.hu/wiki/index.php?pa...FIgnitionTable

 

I use Aaron's:



General consensus is that it's close to stock, safe to run in boost, generally good for everything all around.

No complaints here either.

 

+1 Mine's tweaked a little bit but the table runs VERY well

 

Other than the vacuum cells, that's not really close to stock timing at all. Stock TII timing is very aggressive up top, while that falls off a cliff and goes very conservative in all boost cells. That looks more like a base map, so there would be a lot of room for adjustments.

This is stock S4 TII timing from my Rtek: https://www.rx7club.com/2nd-generation-specific-1986-1992-17/stock-s4-turbo-timing-maps-warning-those-stock-ecu-943159/

I use Arghx's "conservative" map: https://www.rx7club.com/rtek-forum-168/new-boost-based-timing-maps-885556/